Posted by RTR on April 11, 2012 at 08:11:36 from (216.226.179.180):
John,
Another question......got the 140 troubleshooted and found a bad regulator. Thank you for the guidance.
I've got an IH 424 Deisel tractor with the same charging system (12 volt generator with regulator), BUT it does not have an ammeter. It only has a "dummy light". I noticed that the light remains on after cranking the tractor and stays on until you rev the engine and let the tractor run for a little while (about 2 minutes at half throttle). Once you let the engine back at idle, the light comes back on. I have reason to believe that the charging system is faulty somewhere. All of the wiring is original, untampered, and looks really good. I don't believe that is the issue. So tell me.....how in the world would I troubleshoot this charging system since it does not have an ammeter to let me know if it is charging??? Looking at the light is like a baby crying.....it can't tell you what's going on. Am I going to have to get out a multimeter, or is there another way to troubleshoot?? IF I have to use the multimeter, please instruct on where and what settings to use.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
