Posted by TylerFarmallH on August 27, 2012 at 19:41:07 from (69.71.1.1):
[img]
Hey guys, these are some pictures and an attached youtube link of my neighbors 400 conversion I am having some problems. I have done this one before succesfully on an H but this one is giving me fits.
The Alternator Hot wire is going to the amp Gauge
The other line going to amp guage is from the positive side of the coil.
I think the problem comes in for me with the starter, it has a seperate line for the solenoid, but that also how it was wired for 6 volt and it worked fine... Any help is appreciated!
Everything checks out fine as far as what is hot and what isnt compared to my succesful H conversion. but the switch on the 400 doesnt have a hot wire running to it. However the switch worked fine as a 6 volt. We literally changed nothing in the dash panel. I hope you can look at the video link I posted too. Just copy and paste it into Youtube.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.