Posted by tom dowling on October 14, 2012 at 17:59:22 from (98.233.44.20):
I just finished rebuilding the carb on my 400, went to start her up and the starter sounded strange, thought the bushings were goin bad, pulled it and found the entire nose cone broke off!!! Its not right in there where I can feel it or reach it through the starter hole or either bottom inspection covers so it must be beside the front of the flywheel on the bottom side. As far as I can tell the only way to get where its at would be to split the tractor. I"m thinking about leaving it in there if its not hitting the flywheel but I"m not sure how smart that would be. Any ideas how to get it out would be greatly appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.