Posted by FC Andy on February 21, 2013 at 15:05:39 from (74.126.84.52):
Ok, I bought a set of duals for the old 806 for this year. 18.4-34's on 9 bolt rims, as everybody seems worried about running clamp on's on those tractors. Plus, I think axle duals look better on the tractor. (mine had clamp- on's before I owned it, I have the eyelets to prove it.)
Anyway, drives are set with the "dish" of the hub inward, on the "Inner" bevel. I had them set this way for plowing. I'm considering leaving the hubs "In" and moving the rims to the "outer" bevel, effectively narrowing the tractor. I'm hoping this will allow me to set it all the way in for pulling the planter, and for mounting the duals, and also allow me the room to slide the whole wheel out to plow with, in the future.
I won't be plowing much in the future, but possibly some, I purchased a Chisel Plow last fall. Tractor needs duals to pull it well. If I make some money farming this year, Hopefully there will be new tires mouned up this fall to pull the chisel, to match the 2 year old "new" drives. :)
So, where I'm going with this is, How does everybody else set up their tractors?
A few more pieces of info on mine- I don't have the factory long axles for duals. I have standard length axles. I think this will mean that I will need what I call the extended length M+W hubs, and slide the drives all the way in to mount the 9 bolt hubs. I already have 1 of the M+W hubs, and will need to find another to match.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
