Some of you must have read my post within a minute or so....
I have to apologize for an error I made in my initial posting... I incorrectly said my tractor is a Super C.
It is a Super A....
When I read the post after it was accepted, I noticed my error, then edited the post immediately. I have a friend with a Super C, so that's on my mind also.
My reference to casting dates were about information I found on the transmission, hydraulic unit and the tube. (10.8.W) (1.24.U) (10.16.W)
The engine DOES have C-123 cast into it (left of the serial number)
The serial number does not have any prefix or suffix, only 73218 stamped onto machined casting under plug one.
Slater... Sorry, I did not mean to infer I thought you are wrong, I was just trying to close the loop a little tighter. I have not found a date code on the engine yet. If it's warm enough tomorrow, I will power wash it and look again.
Thank you all for your patience, interest and assistance.
This post was edited by djhammerd at 19:23:17 02/26/14 3 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
