Posted by gqjoe on January 09, 2015 at 22:29:32 from (173.210.167.202):
Hello. I am putting a new 17gpm hydraulic pump into a 606 with serial no. 2485 s-y. I do not have a three point hitch on the back or a piggy back pump on my original 12gpm pump that failed and I removed. On the filter side I purchased the Precision Engineering filter extension kit to help with the pump noise and chatter. My question is what else do I need to do to complete the upgrade and also how do I check for backlash between the pump gear and PTO gear so that I can get the correct gasket thickness between the over and tractor body. One more thing, what suction tube do I need to use? The parts diagrams have two to choose from, based on the serial number, and my new one would be suction cross tube 384022r92 but what is the difference between tubes? my old suction tube has the number IH 383254R91 and I cannot find any refence to that number anywhere. Any help and/or pictures are greatly appreciated!!! Thank-you!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
