Wankel rotaries should be compared to 2 stroke engines and turbines, not just 4 strokes. Mazda was one Japanese outfit that built them for their purposes, others made jetskis and snowmobile engines, small aircraft engines. Norton in England has their motorcycle running around- often with police officers on them and NSU had their cars. Curtis-Wright bought early license for rotaries in US "Transportation" market while GMhad purchased license later for Brazillian market. The GM publicity about selling rotary engined cars in US in original Vega bodies got a letter from the Curtis -Wright lawyers saying OK, but it will cost you a good chunk of cash for every one you sell since we bought a license earlier for this market area and several laws and case laws regarding license and patents means we"ll win if we have to take you to court- this letter will also cost you the legal notice fee, pleas pay in 10 days or court service will start in 12 days with seizure of all product in dispute. GM paid for lettter and squeezed V6 in Buick body shell-had to buy tooling previously sold to Kaiser back from AMC, Pontiac got old Iron Duke in their shell and vega got a hood bulge for their short life cylinder engine. Ford has done some research in partnership with old Curtiss licensee and Mazda, some compresor research has gotten some return. Rotax and Norton motorcycle engines were originally classed with 2 stroke engines and used a 2 stroke fuel/oil mix for extended tip seal life, Kaw jet skis also used outboard mix until EPA got real picky. Fuel economy down for EPA as quickest way to meet standards was afterburner before cat in cars. Original Wankel idea was afterburner feeding extra turbine blade for airplane engine similar to early Coanda hibred engine or the current marine combination diesel engines with coupled low pressure turbine. Works- but the cost of compressor and turbine goes up higher than market competion for most applications. Mazda had a good run, won a few races and got some R&D knowledge, got some good advertising to help sell some other models. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
