I have not done this type of thing but I have a few questions. Is the Ford 302 V-8 internally balanced or externally balanced??? If it is externally balanced you will need to use a factory flywheel. If it is internally balanced then you can use the tractor's flywheel/pressure plate setup.
I have done a few motor switches in some trucks and other equipment. If the bell housing is big enough, you use the engine's factory flywheel. You then make an adapter plate to bolt your block to the transmission housing. The using the factory engine flywheel you have a machine shop drill holes to use the tractor's clutch/pressure plate setup. With the factory flywheel you can use the regular starter and mounting place. You just need to make the hole in your adapter plate in the correct place.
If the factory engine flywheel will not fit inside the tractor's bell housing then you will need to do some more work/cost. IF the engine is internally balanced you can have the tractor's flywheel made to fit you engines cranks shaft. Then you would use the tractor's starter if possible. The trouble is that the V-8 engine maybe to wide for that to work well. You should be able to make it work with the starter mounted low and next to the oil pan tight.
If the engine is externally balanced and the factory engine flywheel does not fit inside the tractor bell housing then you have an expensive issue. You either have to make an an adapter that is large enough to fit the engine and deep enough that the factory flywheel is in front of the tractor bell housings. If you do this you will need to make an transmission input shaft extension, this is not cheap. The other option is to have a flywheel made that will go in the tractor bell housing but is balanced like the engine needs. This is expensive too.
I have seen some guys make an adapter that replaced the tractor's bell housing completely back to the transmission. These are harder to make and usually do not look very good either.
Maybe if you post this down on the Pullers forum they may have better answers. Some of them may have fitted car/truck motors into tractors to make modified pulling tractors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
