Posted by John T on November 30, 2013 at 05:33:49 from (216.249.76.176):
While on the topic or receptacle wiring, may as well toss out another question/preference so we can all crawl back out of the woodwork (ME included lol). Like I said, I love and enjoy every post on this stuff and the more the merrier I figure, its NOT a race ya know. If I ask a question and get 10 same opinions I feel MUCH better then if 5 say one thing and 5 say the other lol
Okay, say you're running out a receptacle branch circuit in which case you wire INTO a receptacle and then go OUT OF it to another receptacle downstream. Many times you see where an "electrician" or "Billy Bob" perhaps??? in effect used the 2 screws on the side of the receptacle TO SPLICE THE IN AND OUT BRANH CIRCUIT WIRES.
As yall know its not good to have an Open Neutral and its the UnGrounDED Conductor that gets switched, NOT the GrounDED Conductor ie you switch the HOT NOT THE NEUTRAL (don't break a Neutral)
Theres an alternative, of course, if you don't use the receptacle as a splice. That is to run 3 wires (in,, and out,,, and pigtail) into a wire nut to splice the branch circuit wiring and then run the one wire pigtail to the receptacles screw terminal. If an electrician is replacing a receptacle he doesn't have to break the Neutral circuit open, he just removes the pigtail and attaches it to the new receptacle, even though the circuit is shut off at the panel breaker.
SOOOOOOOOO Billy Bobs and Electricians alike, WHATS YOUR PREFERENCE. PS, I preferred deep boxes where possible to allow room for wires and splices and wire nuts etc etc. It takes up a lot of room just to ground a metal box plus splice the grounds plus wire to the receptacles ground lug PLUS splice the hot and neutral LOTS OF WIRES N NUTS IN THERE LOL I liked those greenies grounding wire nuts with wire hole out the top and the little braided grounding pigtails for box ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
