Posted by glennster on February 02, 2014 at 17:14:50 from (99.90.9.201):
ok here is the latest on the 2001 powerstroke in our 450 s/d wrecker (5spd 140k miles) it has been having intermittent power losses. truck will run fine and then just loose power. will barely run 40 mph. has already been to 2 different diesel shops. many thousands of dollars have been spent to correct this problem. sensors, fuel filters, oil changes, air filters ect. never threw a code. so out of desperation, dropped the fuel tank and found a little goo in the filters in the pickup. and the pickup was sucking air. replaced that and also changed the cam sensor with a napa one. didnt help. had another diesel mechanic work on the truck over the weekend. check all the wiring harnesses, all good. so he decided that the napa cam sensor was at fault. new ford sensor. the he changed the oil pressure/fuel sensor (above left valve cover. nope. then he changed the temp sensor. nope, then the temp sender. nope. then he changed the pcm. nope. now it misses bad and backfires. finally threw a code, he said injector synchronization. but he is at a loss. now we are in worse shape than before. arrrhhhhhh....another couple grand down the toilet. i wonder if i can put an old 1150 cat in this truck......or an old detroit.....i plan on re-scanning thetruck tomoorow and see if i can pull any new codes with our modis scanner. he was using an otc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
