Posted by Billy NY on November 12, 2015 at 09:58:18 from (104.228.35.235):
In Reply to: Ford 4600 head gasket? posted by leviskuse on November 12, 2015 at 09:30:25:
Run that with coolant in the crank case for any time and you can rest assured the bearings will be ruined in no time. That disk is too big for the tractor, or so it seems. Its just shameful abuse to use a tractor like that.
You had best repair this correctly or you will lose that engine and you may have already done significant damage to it by now, coolant and crank bearings do not mix.
There's a reason the injector pump is factory set, increased fuel and load that exceeds the tractors design is foolishness, the 4600 is a well regarded tractor model that will serve any owner very well, makes no sense to abuse something like that, in my opinion.
Coolant for these is very important too, it needs to be maintained properly, cut 50/50 - 60/40 if you like, using distilled water and anti-cavitation additive. Run it without proper maintenance, coolant per the previous and expect coolant in the combustion chamber when it cavitates through.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
