Posted by notjustair on March 02, 2017 at 18:56:38 from (184.191.48.136):
I'm looking for "conventional wisdom". I'm rebuilding the front end of the old truck - 35 Chevy 1.5 ton. My uncle chored with it for the last 30 years and had it all messed up. One of those "take the play out of the front end by cranking the tie rod adjustment all the way in" deals. You have never seen so much bailing wire and 16 penny nails used as keepers. What a hot mess.
I've replaced the king pins, drag link, and tie rod ends. Not having a starting point, what is general wisdom as to a starting point for threading tie rods? Is half way a good place to start from so I don't have to go so far to adjust toe-in? I'm used to doing old VW's, so I'm used to running toe in at just under 1/4 inch. How's that for something of that age? With bias ply tires and 80 year old springs I'm betting tire wear shouldn't really be a concern. It will just be nice to not have a full turn of play in the steering. It's been in the machine shed for the last two weeks getting a new front end and it's time to get it back out there doing chores!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.