Posted by rossow (mn) on September 09, 2018 at 08:10:20 from (69.24.174.32):
I am rebuilding a small (4x7) trailer. It has an old beam-type axle from a GM truck, probably a 3/4-ton. The rims are tube-type 8-hole 15x5.5. The tires are old tubeless radials but have tubes and are rotted. The trailer will rarely see off-property use but I want to retain the on-road, short-trip option. I want to use modern 15" radials -- with tubes to accommodate the old rims, of course. (Caveat and apology: I'm only familiar with one-piece automotive-type rims.)
I have a couple of questions:
(1) The rim has an outer ring that is free to rotate on the rim when tire is off; the tire bead seats against that ring. Does that ring affect method for mounting/dismounting? I ask because I usually dismount toward the shallower offset but had a rough time getting the old tire off.
(2) Does anyone know of a more modern rim that will fit the old truck hubs? Tubeless rims would be great.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
