Posted by Bryce Frazier on December 25, 2019 at 14:45:20 from (67.143.192.55):
First of all, Merry Christmas to all my friends! Hope all is well for all of you!
My dad and I are considering building another farm shed, no sides or anything, just a roof.
I've got a couple mobile home frames, and we are considering using the H beams for our main beams to set trusses on, rather than wood of some kind.
My dilemma though, how do I go about figuring out what the load of those beams is, and pole spacing, span, etc. I understand the "wider" the shed is, the more weight there is, and the less I could span with the steel, meaning more poles per side. So, there has to be math to figure this out, but I am overwhelemed, and don't really know where to start? Don't really know what to use size wise for poles? I would be using full size cedar poles from the property, setting on concrete pilings.
Anyone have any advice?
My H beams are 2 3/8" wide, 8" tall, and 3/16" steel. They are 45' long. I am considering have a "V" style roof, so the two outer runs would be the same height, the center one would be considerably taller to get the correct rise/run of the roof. I would want to aim for a 4/12 pitch, because we live in snow country, and I do nottttt want to shovel! :)
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.