Posted by SeeMRun on May 27, 2022 at 13:04:17 from (72.168.144.131):
I have a ford 2000 series 1966 3 cylinder tractor . I'm trying to set the timing but can't find what it needs to be set at. I am being told most likely the timing is the problem, but can't seem to find any info. On how to set the timing for this make/model tractor. Can anyone give me step by step guidance on how to set the timing. Thanks.
In addition;
I just replaced the original engine with a engine that came from a running tractor. engine compression was 110 to 120 at the time just before they pulled it for sale. I have not rechecked compression since then, This is an engine block that I replaced the original with and placed all my parts from the old engine on, except the new coil, new plugs, and a new fuel filter and also replace the gas will fresh. The tractor turns over but will not fire. Any ideas will be greatly appreciated.
This post was edited by SeeMRun on 05/27/2022 at 01:24 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
