|
Tractor Talk Discussion Board |
Smart Guys and Idiot Lights
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don H on May 01, 2002 at 12:53:25 from (165.29.117.39):
I need a smart guy to help me get rid of my idiot light (temperature) on my '74 Ford 4000 with a 3 cylinder diesel. The sending unit hole is too small to allow a mechanical temp gage to be installed. Oil pressure was easy-I just screwed in an elbow and added fittings until I got to the right size. Temp is different-the sending unit needs to be imersed in the coolant stream. Does anyone know of any mechanical gages with small sending units? I've added a gage but it doesn't register anything until the temp gets to a certain point and then the gage pegs. This makes me nervous on a 100 degree day pulling a round bailer. Thanks for any advice. I posted this on the Ford page but got no response.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
