Tractor Talk Discussion Board |
How to fix Tree Farmer turning ram brackets...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill on October 04, 2002 at 15:33:52 from (64.12.96.236):
I've got a skidder a guy wants me to fix, and I thought maybe somebody here had done one of these and knows an easy way.. The brackets on the front frame that the steering ram ends engage have worn their holes enough there is substantial play in the steering. The brackets are about 5/8 steel and the holes are 1.75 inches or so. If the pins didnt have to go thru Heim joints on the pistons I'd just make some oversize pins, but we can't do that. Should I: 1: build up the hole with weld and grind by hand to approximately the correct diameter?
2: Slit the bracket, heat it up with a rosebud, and weld it back together after hammerring it smaller around the old pin? (With appropriate V'ing of course..)
3: Make mild steel bushings on my lathe to fit the pins, about 3/8 thick, torch the old pin holes out and weld the bushings in with appropriate v'ing and cleaning?
Or is there another way? If it was the rear holes it'd be a lot easier, as they are right out in the open. Unfortunately the front holes are buried beneath the floorboard and one can only get a right angle die grinder to them due to interference of the floor.
I'm a halfway decent welder, and can use either MIg or arc for this job. Thanks for any help! Bill
Follow Ups:
Home
| Forums
Today's Featured Article -
Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|