|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Should I w
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve on July 14, 2004 at 18:52:13 from (65.41.8.227):
In Reply to: Re: Re: Re: Re: Re: Re: Re: Re: Re: Should I worry posted by Mark - IN. on July 14, 2004 at 18:24:17:
I took the bolt out and dried the hole out with a airhose then put permatex #2 non-harding on the bottom of the bolt at the threads and put it back in. I waited for about 3 hours then, put some K&W block sealer in the raditor and ran the motor at idle, accoring to the instructions on the sealer. while running the motor when it heated up in about ten minutes the bolt started leaking AGAIN! Also I just had a valve job done on the head, and they also milled (shaved) it. I dont know if they checked it with the ultraviolet light though? Is it the head gasket or a small crack in the head. Yall HELP ME PLEASE ! Thanks Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Tire Fluids - by Curtis von Fange. It came as a surprise. The tire on the tractor needed to be pulled off to get to the brakes for service. The tires were blocked, the rear end raised on jacks, the lugs loosened and the tire loosened from the hub. Then, as the big lugged circle of rubber slipped off the last wheel stud it became apparent that there was more there than just an empty tire. Four hundred pounds of rim, tire, and fluid dropped to the ground like a sack of wet cement. Fortunately the installer jumped out of the wa
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
