Tractor Talk Discussion Board |
Re: Death of my 1999 Superduty F-350
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin Bismark on October 09, 2004 at 23:23:30 from (152.163.101.7):
In Reply to: Death of my 1999 Superduty F-350 posted by Todd in Indiana on October 09, 2004 at 05:08:28:
Are you sure that you don"t have a bad cam sensor, had a buddy that had that go out on his, sputtered and died, let it sit for a while and it started up, and then died again a few day"s later, $180.00 bucks later and it was running again, I have one parked next to my garage and it"s the best truck I have ever had, love it, plan to drive one as long as they make it, that 7.3 engine sure seems to be a good one, has more than enough power to pull anything I have ever tried to pull, and then some, have a buddy in Iowa that has been through the Chev and the Dodge and then got a ford with the power stroke and never went back to the others, I have about 188,000 on her now and think I will have to change the throttle sensor, they don"t have a mechanical linkage anymore on these trucks so when you are going real slow she starts to surge once in a while, and had to put a new vaccuum pump on it to control the heating and cooling, and that was another $170.00, they are great trucks but there isin"t anything cheep about them, they claim that you can come off the road from a long hard pull and just shut her down, but I still let her run for a little bit to cool the turbo and engine down, good luck with her.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|