Tractor Talk Discussion Board |
Re: How do you plow snow with your tractor??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Evans on January 24, 2005 at 11:27:51 from (209.41.233.108):
In Reply to: How do you plow snow with your tractor?? posted by Davefr on January 23, 2005 at 12:17:00:
I use a Kubota L-275 to maintain my 1/4 mile by 15' wide drive. On back is a Woods RB6 set at about 30 deg angle with the lift arms sucked over to right side with the adjustment turnbuckles about 6" off center. Put 'er in 6th gear, lower the blade so it lightly kisses the chip & seal surface and let it rip. My first pass is going downhill so when I encounter some heavy deposits of drifting, I can blow thru this. The next pass going uphill is a bit dicey as the Kubota wants for weight and traction. Central Ohio has been rather tame snow-wise the past three years. The old times of really opening up the drive are past due. It's been years since I've had to put the chains on for some real man-size snow removal. I also got a loader for it two years ago so I'd be ready for those times when I used to tell my wife "I hope it doesn't snow anymore; I've got no place else to put the snow." Since I got the loader...well...it figures. No afternoon-long adventures--me against mother nature. I rarely back-bladed before I had the loader. I will probably not back blade at all in the future. My brother plows with our 504 and a fast hitch 8' blade. He puts it in 4th and whacks the throttle open. At that speed the snow seems to fly off the angle of the blade--much like a commercial road plow. The 38" rubber on the 504 fascinates me with its ability to get that tractor thru heavy-going without even sneezing. Two sets of rear weights don't hurt anything either.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|