Tractor Talk Discussion Board |
Re: Dump Truck into a Dump Trailer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RodinNS on September 05, 2005 at 20:18:47 from (142.177.104.133):
In Reply to: Dump Truck into a Dump Trailer posted by SteveTinNY on September 05, 2005 at 16:16:08:
Sounds like you have a project on the go.... If it was me, I think I would power the hoist form the tractor hydraulics, unless the hoist is a scope. The standard old scissor hoist should be fine. The scope will most likely require more oil than the tractor can supply. I'm not sure I understand what you plan to make the trailer from. A separate new trailer that you will mount the box on, or just cut the old truck frame up and use that. If it was me, I would probably strip the cab, engine, tranny, etc. Then, just cut and bend the frame rails in to make an A frame hitch out of the truck frame, if there's enough left of the frame to do that. Build up a hitch, plumb the hydraulics, and you're good to go. That's the quick and dirty. I wouldn't worry about changing the wheelbase around. The tractor drawbar can well handle any weight the front end of the old truck used to take. Just chop er off, and bend it together, and then sew it up with the welder. Just remember that the length of the A frame hitch will be determined by the rear wheel size on the tractor. The trailer must be far enough behind so that the wheels don't contact the A frame. However, the longer it is, the more weight that will be concentrated on the tractor's drawbar. Any other questions, just fire away. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|