Tractor Talk Discussion Board |
Re: TRUCK /DEALER PROBLEMS ADVICE APPRECIATED
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by VADAVE on December 07, 2006 at 04:04:18 from (63.164.202.130):
In Reply to: Re: TRUCK /DEALER PROBLEMS ADVICE APPRECIATED posted by ChevCase on December 06, 2006 at 20:45:45:
ChevCase let me tell what is wrong with slip in (simple) bedliners. 1)they retain water between the liner and the truck thus promoting rust which will be serious in about 5 years. 2)they're made of plastic and with just a little frost and a slight up grade will unload the truck. Had it happen twice with a load of lumber, laid that load right on the ground. Spray on liners don't do either of these and they should not have air pockets. Now let's talk about undercoating. If the plan is to trade vehicles every 5 to 7 years, as the manufacturers want you to, then undercoating is unnecessary. However if the plan is to keep the vehicle 10+ years it becomes a different story. Don't believe me? look at ten yeat old trucks with the bottom rusted out of the tailgate or the seam along the sides showing rust. I had a Jeep with the good Dana axles and undercoated, had no rust on the body but after 10 years getting work done on the axles had increased cost just due to the accumulated rust and that truck was garaged.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|