Tractor Talk Discussion Board |
Re: TRUCK /DEALER PROBLEMS ADVICE APPRECIATED
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dhermesc on December 07, 2006 at 06:21:45 from (68.110.220.22):
In Reply to: Re: TRUCK /DEALER PROBLEMS ADVICE APPRECIATED posted by VADAVE on December 07, 2006 at 04:04:18:
Under coating doesn't last 10 years. As he posted it goes on thick and goopy. After five years of wear, heat and wet the undercoating cracks and takes the original factory finish with it, just like if you apply any finish too thick. Moister and salt eventually works its way between the undercoating finish and the metal causing even more rust. I've seen plenty of older expensive cars with owner that opted for this "protection" that suffer horribly from rust even though they've had the best of care. If you're really concerned about it have your car put on a lift every year or two and have the visible rust sanded and the affected areas painted, it will cost you a couple hundred but it actually works. If "undercoating" a car would prevent it from rusting all the manufacturers would do it and offer 10 year rust through warranties. Instead (as in this case) the manufacturers don't even allow their dealerships to do it since it ruins the factory rust proofing and makes any electrical or fuel line repairs a real bear.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|