Re: Help A Dummy?

Posted by Pete in MD on April 12, 2007 at 14:27:27 from (71.248.56.51):

In Reply to: Re: Help A Dummy? posted by Allan In NE on April 12, 2007 at 14:13:22:

Allan,

Transfer punches are similar to straight drift punches only they have a small point on one end.
You clamp the piece with holes to the piece you want to drill matching holes in and then put a transfer punch that just fits in each hole and smack it good with a hammer. This leaves a punch mark in the other piece which marks the center of each new hole. Drill each hole with about a 1/8 bit to give you a pilot hole and then increase the drill size to required diameter.

Pete

Replies:

• Re: Help A Dummy? Allan In NE 14:38:08 04/12/07 (9)
  • Re: Help A Dummy? PhilcaseinWPa 16:32:08 04/12/07 (0)
  • Re: Help A Dummy? Pete in MD 14:50:45 04/12/07 (2)
    • Re: Help A Dummy? Allan In NE 14:54:21 04/12/07 (1)
      • Re: Help A Dummy? Pete in MD 15:26:12 04/12/07 (0)
  • Re: Help A Dummy? Dave in Tx 14:49:27 04/12/07 (4)
    • Re: Help A Dummy? Allan In NE 14:56:56 04/12/07 (3)
      • Re: Help A Dummy? rgvtx 15:16:01 04/12/07 (2)
        • Re: Help A Dummy? cadet trooper 15:43:33 04/12/07 (1)
          • Re: Help A Dummy? rgvtx 18:13:59 04/12/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]