Posted by Billy NY on January 25, 2008 at 10:52:23 from (205.188.117.74):
Well that chimney has been thoroughly cleaned, even fired up a welder to make a tool after finding a piece of pipe that was bent just right for the vertical portion of the flue, welded a piece of angle on the end to pull the creosote grinds out, set the pipe, pulls smoke nicely at the elbow and I'm within the specifications it calls for from a combustible floor/wall.
On that note I'm set to go light it off, I did check this stove out thoroughly, seems to be fine, everything works like it should, it's an old Martin Industries/Ashley Automatic model 25H F.
I'm thinking the abundance of dead elm, and other hardwoods that have been down, many resting on limbs in the air, will be the best wood to burn, particularly the standing elm as it's bone dry, then the others if needed, figured those would not be as seasoned as they are not cut up, probably won't take long after they've been cut. Oak, Cherry, Maple and some White Birch.
That in mind I think the creosote build up should be at minimum, operating the stove so it burns clean, not choked out too much, the Elm will probably last me the rest of the season and produce the least creosote.
What I'm wondering, is an annual clean out say after the season's over, (check again before firing up in the fall) the normal interval or should I be checking more often, based on the kind of wood I'm using ? (there certainly won't be any green or unseasoned wood going in there)
The other thing with this stove is I remember leaving a bed of ash just a little below the level of the front door, what is recommended here, it's got ash in it still, I found a piece of newspaper, with a birth notice of January 27, 1980 ! Should I clean it out or leave the bed of ash, seems it would insulate the bottom, floor is concrete anyway, that is how I remember doing it then, not sure if it was correct or it does not matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
