Posted by Bruce Hopf on May 18, 2008 at 16:42:45 from (216.46.133.10):
I have pretty much taken apart my buss saw, making darn sure that everything checks out OK, just to bee safe. I have taken the blade, and using a wire brush on my angle grinder, I cleaned off all the surface rust on the blade. I removed the PTO driven gear box, and drive pulley assembly, and I'm going to drain, and flush out the old gear oil. Then put new gear oil into it, and reinstall the assembly. I next going to remove the sliding table, and replace the boards on the deck. Clean up and grease the axles, and rollers for the deck, so it will slide nice and easy. I still need to grease up the bearings for the drive shaft for the blade, and the other drive pulley. I have made a new drive belt for the buss saw. For measurements while cutting, I an going to make removable table extenders for cutting into lengths. One for 12" lengths, and one for 16" lengths. For the log side of the blade, I am planning to put groves into the table, one for 12", and one for 16" lengths with the router, for the last cuts. While cutting, I plan to have my bale/grain elevator set up, so that the blocks of wood fall from the saw table, into it, to remove the blocks of wood, and put into a pile. I will use the tractor and loader to carry the 4' logs to the saw, and slide them onto the saw from the bucket. Now that my buss saw is PTO driven, what rpm is recommended to run the tractor at wit a 540 rpm PTO? Your input is greatly appreciated. Thanks. Bruce.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.