Posted by LOU from Wi. on October 26, 2009 at 08:04:36 from (174.124.65.225):
I could use expert advice on a couple of questions. 1St. Thinking about an oversized Loafing shed for the 706. Something that the tax collector can"t charge us (to pay off the national dept)because it will be movable on skids. Wanting information on using flat trusses spaced 24" oc. Bldg will be 24 ft in length X 20Ft in width X 12 ft high at the rear. Sloaping (I Think) is 1"for every 10 ft. Is that correct? 2nd question.What kind of door,or doors ? Can"t use overhead doors with garage door opener,because shed will be movable. WE got so much machieniery now in the garage,so the shed will hold tractor, bobcat, log splitter and other small mowers.etc. Thinking of using log splitter to sink cleats in truss assembly. What is the opinions . Would appreciate GOOD SOUND ADVICE.Pictures would be of great help if you folks have em for this type of Structure!! Thanks in advance. LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
