I guess what you're saying is that the pin in the ground merely represents someone's (surveyor) OPINION of where that point (as described on a deed) exits in the "real" world.
The Metes and Bounds system (Federal Range-Township) is a "perfect" mathematical representation of land (on paper). When Farmer John sold a "Section" to Farmer Bill, they probably didn't worry about where the theoretical corner point was. A "Section" is a decent chunk of land (640 acres). The deed probably just said "Section 5 of T2N, R3S" or something like that. As land got subdivided into smaller pieces, lengths along section lines and angles started to matter. And turning these descriptions into physical location markers was probably a challenge when we're talking about forested, hilly, swampy land that has to be tromped over. Factor in the equipment and operator and you could probably get 10 different "pin" locations from 10 different surveyors.
However, as long as the deed descriptions are consistent over time, I'd feel pretty comfortable with having a registered surveyor set the pin according to the recorded legal description before I'd get a lawyer involved.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.