Posted by grayrider on October 27, 2009 at 19:55:38 from (75.120.111.230):
My parents have a rural (wooded) piece of property that they have lived on for about 45 years, land was originally surveyed when purchased and corners were marked with rebar steel, several years later on NE and SE corners the markers dissapeared so land was resurveyed and marked once more. I know exactly what happened, the property owner on east side of them pulled up the markers. We have talked about this now for about the last 25 years, now this guy wants to dispute the landline and where the corners are. My parents are going to pay for a third survey of these two corners and this time when the surveyor puts his pin in the ground at each corner I will immediatley dig holes 3 feet deep at both locations and put railroad iron up for new corner markers leaving about 4 feet above ground, will also back fill holes with concrete, then I will paint the railroad iron bright yellow! The guy is claiming land that does not belong to him and now is the time to nip this in the bud. My parents are getting on up in years and issue has got to be resolved. They never have walked their boundry lines to keep a check on things, maybe if they had done so over the years this wouldn't have happened. If this guy attempts to remove the railroad iron that I'm going to use for corner markers this time we will have him prosecuted! Anybody else ever have this problem? I would like to mention that I also like to use large truck axles for corner markers as you can drive them down flush to the ground and the hub/flange end of axle is easy to find with metal detecter if it gets covered up. But with this land grabbing neighbor I want hime to see markers sticking up about 3 or 4 feet above ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.