|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: More MD questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad Whitty on July 11, 2001 at 13:38:39 from (206.190.72.128):
In Reply to: Re: Re: Re: More MD questions posted by Haas on July 11, 2001 at 04:50:51:
Thanks for the reply. Yes, there is a flat plate bolted just in front of the battery, on top of the transmission. There is no extra holes on the plate. That "extra" 1/2" pipe fitting comes out on the right side of the pump, at the bottom rear of the pump (5 o'clock postion)I see the 4 3/8" bolts holding the pump up in the belly of the MD. I have one more question. I talked to "Quality Farm and Country" the other day in Iowa about their catalog listing for a wide front end that fits the M. I asked if it would fit the MD and he said yes. However, the front end does not come with the hub and rims. My MD has one wheel on the front, not two, like yours. Is it easy to find hubs and rims for this wide front if I ordered it? I live in the mountains on the Central Coast of California so the wide front is important. BTW, I was in the mountains of NC(Blowing Rock,NC) this time last year. I was born and raised in NC(New Bern). Are you located near the NC/Tenn state line? Thanks again for the help, Brad Whitty
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
