Farmall & IHC Tractors Discussion Board |
Needing F30 advise.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tyler on October 12, 2001 at 11:51:44 from (151.201.133.63):
I pulled my Grandfather's 1938 F30 out of the barn this weedend to start a winter restore project. Five of the valves were stuck and I was able to free up three . The other two still after two hours of penetrating oil and working them up/down with a bar are still stiff. At what point do I call it quits and make a plan to pull the head? If I do pull the head what other problems will I run into and issues to consider. I have priced the gasket set at about $150. Also if the head is removed should I change the piston rings and do a complete valve job or just reseat. Please advise! (I'm new to this stuff but love old tractors.)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|