Farmall & IHC Tractors Discussion Board |
Concurrences
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on May 08, 2007 at 07:44:01 from (207.170.88.206):
In Reply to: Re: Farmall M Rained In posted by Janicholson on May 07, 2007 at 19:18:48:
(1) You need a rain cap. Indoors is good to, but an M is a BIG vehicle... (2) An oil and filter change is perscribed, by almost every manufacturer of motor vehicles world wide, as routine preventative practice any time moisture is observed in the motor oil. At least crack the drain plug and look for water, as Jim suggests. Or just change it anyway and have done with it. Yes, changing the oil cold is less beneficial than changing it with the engine warmed up; however, water in the oil is an EXTRAORDINARY CIRCUMSTANCE. Changing the oil and filter is cheap. Yes, the filters have gone up quite a bit lately; so have bearing kits! After changing the oil, or at least ascertaining its integrity, start the tractor and let it reach operating temperature, keeping a close eye on the pressure gauge, of course. Warming the engine will help "cook out" excess moisture.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|