|
Farmall & IHC Tractors Discussion Board |
IH 460 PTO adjustment (560)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike on April 27, 2003 at 13:19:01 from (12.216.49.223):
The PTO on my 460 utility runs all the time. No matter if lever is engaged or not. When I disengage it, it does not run at full power, but it still turns my bush hog squealer mower at a good clip. I have adjusted the linkage in and out and cannot find a good position that completely disenages it. I noticed there are two square key notches on the engagement shaft coming out of PTO it holds the linkage for lever. Can this be moved to a second position for adjustment?. Today I changed the hy-tran fluid in it and cleaned the vent cap. It was clogged shut. Any ideas? Pretty sure this is same PTO as on 560 and probably some other models.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
