|
Farmall & IHC Tractors Discussion Board |
Re: IH 484 blowing and dripping oil from crankcase
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Quebec Red on September 08, 2003 at 14:15:25 from (64.228.165.167):
In Reply to: IH 484 blowing and dripping oil from crankcase bre posted by TedM on September 08, 2003 at 03:14:06:
The 484 is a 3 cylc 179 inch diesel. This is half of a 358 German diesel used in o88 and 3288 tractors and 1420 and 1620 combines. These motors need to be run hard and worked to eliminate slobbering. Also poor oil, poor previous maintenence, or poor or stale fuel would not help.Worn valve sleeves will also cause this condition. Before spending dollars on repairs, do a basic maintenence and work the unit to its maximum for 3 or 4 hours. A dyno would also serve.It is the nature of these German diesels to dribble and slobber when under light load. (155,179,206, 239, 246, 268, 310,358, and 402 inch motors.) You would know if it was only running on 2 cylinders.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
