|
Farmall & IHC Tractors Discussion Board |
no fire to distribitor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Huston Lloyd on October 29, 2003 at 18:10:07 from (68.53.160.176):
I have a 1966 farmall 140 31311 J. 12 volt conversion. I bought new points,cond,spark plugs and wires.I pulled the distr. gear all the way out, is there a certain way to put it back in.
This tractor ran well a few months ago, and now it tries to start but cant fire. is there a way to find out whats wrong.I have power to the push button starter and the starter works hard to fire but now fire to selinoid.I even ran a wire from the neg side of the selanoid to the starter and still no fire from the coil. I crank the engine until pressure pushes my finger off the number 1 plug and line up the coil button to the #1 plug and still no fire? what else can I do.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
