|
Farmall & IHC Tractors Discussion Board |
Re: Re: No Steering on my H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tony on December 03, 2003 at 15:14:34 from (216.117.82.124):
In Reply to: Re: No Steering on my H posted by Bob M on December 03, 2003 at 12:43:50:
Thanks for the replies fellas. Thanks for the pictures too Bob. I went back outside after my first post to get a better look at things. After some more disassembly I discovered what both of you diagnosed, the shaft is broken. It broke right where the small diameter turns into the large diameter section of the shaft. The gears and brass bushings don't look to bad. Bob, in your pictures you said that you made some spacers and that the thrust bearing was improperly installed. Could you explain the order of installation with the seals, washers and thrust bearing? Thank you very much!
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
