Farmall & IHC Tractors Discussion Board |
Re: Re: BD154 resleeving - help...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg on June 15, 2004 at 12:51:17 from (4.226.15.135):
In Reply to: Re: BD154 resleeving - help... posted by El Toro on June 15, 2004 at 07:51:09:
El Toro, assuming I do end up needing to resleeve I have some questions: I am a good mechanic but I've never resleeved an engine before. My oil pressure is good and stays good even after hours of running so I don't think I'll mess with the crank. I simply pull the head and pan, take rod/piston assy. out. Then, how exactly do I remove the sleeves? Is there a specific tool I need that uses the top deck of the block as leverage to pull the sleeves out the top? Do they usually come out without trouble or are they more commonly a problem? I more than likely won't rush into this since the tractor still runs fine but I want to get as much info as I can so I'll be ready when I decide to do it. Have you ever resleeved a BD154? What brand name parts should I use and where should I buy them? Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|