|
Farmall & IHC Tractors Discussion Board |
Re: IH 686 Tractor- 70's
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB2 on November 09, 2005 at 17:21:05 from (72.56.121.128):
In Reply to: Re: IH 686 Tractor- 70's posted by 7D Ranch on November 09, 2005 at 16:54:31:
Hi 7D, according to my I&T Shop Service manual for 544 thru 686 P.105 paragraph 302, to check the hydraulic lift system relief valve requires a Flo-Rater test guage. If the release pressure is less than 1800 psi then replace the relief valve. It does not give a location for the relief valve. On P.111 it shows an exploded view of an aux control valve and there is no relief valve build into the aux control valve. Some loaders that have their own hydraulic control valves have a relief valve built into the control valve and it is behind the big nut beside the control levers. Hope this helps
JB2
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
