Farmall & IHC Tractors Discussion Board |
F-20 oil bath air filter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Indiana Mike on December 15, 2005 at 22:33:19 from (71.98.68.131):
I'm new to the area of restoring tractors, so my questions may sound trivial. I just got done getting a 1938 F-20 running again, and I had a couple of things that I was wondering about. First, what weight oil should I run in the oil bath air filter? I have heard 30 wt, but also had heard it was critical to get it right, so I ask. Second, I am having a little difficulty with my magneto. It seems to be grounding out when the spark advance lever is in the "run" position all the way down. Mine is set up that up is off, and down is run. This corresponds to a clockwise rotation of the cup on the mag for run. Any guidance would be greatly appreciated.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|