|
Farmall & IHC Tractors Discussion Board |
Oh... She got the better of me today.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kelly C on January 14, 2006 at 13:41:46 from (63.171.43.140):
That 706 does not want to give up those sleeves.
The pulling disks I have just are not accurate enough. I cant for the life of me get the disk not to catch on the side of the cylinder.
I was out there all day and have nothing to show for it. I even tried to weld a bead along the old sleeve.
That did nothing, cant get it hot enough to shrink it. I ran 3 beads on the #1 and you could touch it right after. All I got out of that was a peice of slag on the deck to fix now. The disk I have is just a cut out peice of steel. That the guy took a grinder and put a angle on the edge. All that does is slide as you put pressure on the disk. I need a machined disk with a 3 9/16 lip on it. So it can make a possitve lock to stay lined up.
Grrrr crappy day.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
