|
Farmall & IHC Tractors Discussion Board |
H/ Rotella Oil?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom Windsor on December 23, 2006 at 20:45:39 from (64.12.116.65):
I went down to the Walmart and then to a local auto parts store to get some 30 weight non detergent oil to put in the H tomorrow. While reading the containers, I became convinced that what they were selling was not what I wanted. I know, that the head channels, the pump pickup and the pan are clean and free of sludge. That leaves the block itself as a repository for sludge. I was thinking that I would put 30 weight rotella oil in it, monitor the oil pressure, and after running a while, change oil and filter, drop the pan and check the oil pickup, and then convert to full HD 30 weight oil. It seems to me that this would be acceptable...are there any down sides that I should be thinking about? TW
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
