|
Farmall & IHC Tractors Discussion Board |
Re: Super A - Steering Seal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on January 09, 2007 at 16:16:47 from (4.227.104.143):
In Reply to: Re: Super A - Steering Seal posted by gene bender on January 09, 2007 at 15:27:48:
I have had the steering wheel off within the last two months so it should come off pretty easy. Dont have a puller, I used a block of wood and a hammer last time. A puller would sure make it easier, maybe Ill get one. I will check the bearing and bushing for sure. There isnt any play in the steering so I think its all good. What I want to know tho is the stearing shaft going to just slide out after I get the nuts off or am I going to have to force it out, or twist it out? I dont want to be banging on it thinking its the old seal holding it in there when Im actually breaking off the worm gears. I know Ill probly find all it out when I get in there but I like to be prepared. Gene, got that other seal fixed on the axle. I had to get my tractor guy to bring his cherry picker but it went smooth. Cleaned the brake band off and everything else and now I even have brakes again. Working on the seal of the side pulley. Ordered one from Case, cost $24.00 and was half as thick as the old one. I decided to put two on there and ordered another one from a car parts place since I had the seal number. The same seal from there cost $5.00
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
