Farmall & IHC Tractors Discussion Board |
Farmall M shutting down.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dej(JED) on January 11, 2007 at 05:29:17 from (66.212.151.134):
My M begins sputtering and shuts down after running for about 30 minutes. If I pull the choke it will run with the choke out for about 5 to 10 minutes, but then it shuts down for good. After it shuts down if I pull the carb plug, I get very little fuel. When I disconnect the line at the carb, I get good fuel flow. If I let it sit, say for 30 minutes, it starts up and runs for about 10 minutes or so and starts acting up again. Is it vapor locking or is there a needle valve and seat problem? Any ideas would help.
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|