Posted by Carden on November 27, 2007 at 06:24:56 from (74.33.249.220):
Pardon my ignorance... My M requires the clutch to be out before the hydraulics will work. I have gathered, from this forum, this means I do not have "live" hydraulics. I found this on the parts page - Hydraulic Pump - For models: M, Super M, Super MTA, Super W6, Super W9, 400, 450, All Gas with Live Hydraulics. (Part No: 128190C91)- $650 - Is this what is required to make the hydraulics live on my M? If so, how difficult is it to install? Does this automatically mean it will be 2 way (up & down) pressure or will I still need the correct valve?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.