Posted by Hoss357 on December 26, 2007 at 09:38:32 from (24.176.33.82):
OK,,here we go still don't have it fixed i'm on my last nerve with this tractor...org.problem was t/a clutch disk was wore out on one side causing tractor to slip...(here is where the fun started)...couple of buddies helped me put the tractor back together after i installed a new t/a clutch/cover plate/bearing...got it close told me to draw it together i didn't think that was right but they showed me how to do it..got it tight the motor wouldn't turn over they told me the batt. was dead waited till they left split it again...clutch disk was bent...replaced engine clutch disk...put back together..when it was in gear w/clutch push in wouldn't roll...put in N rolled fine.. start in N wouldn't go in gear...(have adjusted and adjusted!!!!) anyway was told it might be in the T/A so i installed a eliminator kit(I know but i don't use the t/a on this tractor) put back together and in gear w/clutch in still won't roll,,in N it will roll???????????????????????????????????????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
