Posted by Red Mist on February 19, 2008 at 14:29:25 from (208.61.169.122):
Howdy, boys. Someone posted a question earlier about a 3-ph on a 560 and it prompted quite a bit of discussion. I also want a 3-pt for either my SH or SM. It would be nearly always used for above ground implements. They say you get what you pay for, but my question is: Do I really nead a $700 + $200 freight, dual cylinder "Rolls-Royce" Saginaw 3-point hitch, or are there good performing single cylinder 3-points that please their owners? The salvage yard nearest me has three used ones for sale from $300 to $350, and they all look pretty good. In fact, one looks like a Saginaw, except it has mounting points for only one cylinder. By the way.... my tractors both have two-way valves. I don't want to buy and have regrets - and I don't want to waste $ on something unnecessary. Thanks for your advice. I appreciate all of you. mike durhan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
