Posted by bobs1941m on April 18, 2008 at 19:29:01 from (69.66.129.135):
OK! A couple of years ago, a guy over hauled my dads M farmall. Basiclly dad bought a kit with I think standard bearings. dad never really used it after that,due to bad health. Since he has passed on, and i was givin this tractoer by my mom. Heres the deal, i can start it and it has good oile pressure after is warms up real well it drop just a little above the red mark on the gauge. If i plastic gauge the crank will i be able to get the rite sized bearing to help it hold good pressure?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.