Posted by Bemidji 52 M on December 05, 2009 at 10:57:38 from (209.191.208.117):
The initial problem was that when trying to get it to start it would flood out and gas would poor out of the air intake of the carb.
Cleaned and completely rebuilt the carb checked that all the jets were clear and the float measurements were correct and that the float floated and did not bind.
Tried to start it again same problem split the carb on the tractor checked that the float was controlling the needle valve and was not binding. Still would not start and gas coming out of the air intake.
Pulled the carb put air through all the jets again all clear checked the float again measurements were good no binding anywhere I could here the float rattle when assembled.
Put it back on the tractor same problem. Just to make sure pulled a spark plug and there is spark . Looking for any other suggestions or if anybody is in the Bemidji area that would like to earn some money please let me know. Thanks!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.