Posted by ericlb on June 01, 2010 at 19:14:25 from (72.173.192.58):
ok i messed up, now i got to figure out where, i got my new/old plow depth control installed, [manuel handle], did not come with link between it and the drawbar, now i think this is where im off, i made linkage based on what i saw on tm's impliment hook up photos, drawbar level,flange on control handel paralell to it, all else is hooked up as in the original manuel i have, for the plow, when i try to plow, the plow point will not "dig" into the ground and suck under, it just skips along the top, i need to know the exact length on the original link between the drawbar and the depth control handle, also how sharp is the point supposed to be? this one is about like the blade on a brush hog sharp, pointy but it wont cut ya, its beem 35 years since i tryed to plowand thaty was with a 3 bottom on a m, not a single on a cub, and im sure im forgetting something here but the link must be the first thing, thanks, sorry this is so long
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.