Posted by grandpajohn on October 15, 2011 at 22:14:32 from (206.125.157.210):
I have searched the archives and I just bought an M and I am not familiar with the hyd setup. I have the single action hyd coming out of the left side of the torque tube and when I pull the hyd lever for the belly pump I get 1200 lbs of pressure.
The problem is I cannot get pressure out of the dual action remotes from the christmas tree. As i have read in the archives the single action hyd lever must be pulled back for the christmas tree to work. I have pulled the lever back so that the knob on the bottom of the rod rest on the lever guide located by the steering column and I dont get anything. Do I need to pull the single action lever all the way back as If I were trying to raise a single action cylinder?
When I got the tractor someone had taken the rod off of the christmas tree which makes me think there may be a problem I am just trying to figure it out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
